Package contains 2 spring loaded poles, two grip disks and comes with the new tethered plate. Plastic sheeting is not included.

The plunger and spring are built into the pole. This makes the poles lighter (1.5 lbs. each) and stronger. With the plunger now made of solid polycarbonate, it is unbreakable even when used under the toughest conditions.

Because this product is lighter and more compact it is even easier to handle, store and transport than the original ZipWall KT12.

• 2 poles per box

The reach of the NKT20 pole with the jack attached is about 21 feet. The collapsed height of the pole and jack together is about 6' 9" so it can work in standard height ceilings as well.

The re-engineered jack is now tougher than ever. The polycarbonate wall of the spring housing is now about twice as thick, and the neck of the ball has been beefed up so that the jack is now virtually unbreakable.

With the NKT20 one or two people can put up 100 feet of barrier in just a matter of minutes. With this product you avoid the need for a hoist or scaffolding to secure the plastic sheeting to the ceiling.

The NKT20 fits into the Carry Bag with the jack uncoupled from the pole.

Includes:

• Two 20 foot poles
• Two spring loaded jacks
• Two grip disks
• Tethered plate

Zip-Up can create any size doorway with poly sheeting to control dust, reduce heat loss, or create an instant entrance/exit to any closed area. For interior or exterior use. Zip-Up is perfect for al types of construction. Meets federal containment specs for asbestos removal.

Includes:

• 3" x 7' zipper with pressure sensitive backing
• Two end pieces
• Two velcro tabs

The CarryBag was developed to keep the ZipWall poles and jacks organized and easy to transport. The carrier holds six standard, 12 foot poles with jacks attached. The bag can also accommodate six of the new 20 foot poles and six jacks, if they are unattached from the
poles.

The carrybag is made of 1200 Denier Polyester and will help contractors keep the ZipWall products in good condition during transportation and storage.

Once a dust barrier with ZipWall poles is erected, this five-foot bar, with its soft, spongy edge is attached to a ZipWall pole and jack and lifted into place pressing the plastic sheeting to the ceiling. This creates an extremely tight seal without the need for tape.

Foam Rails fit all ZipWall spring loaded products. Very light weight and easy to install, sealing up a barrier takes just a few seconds without causing any damage to walls or ceilings.

Includes:

• Two complete 5’ foam rails
• Two T-clips

ZipWall side clamps ensure a tight-seal against the wall. When attached to the Foam Rail and supported by a ZipWall pole, the Side Clamp presses the plastic sheeting firmly to the wall.

Includes:

• Two side clamps

These replacement plates have a new non-skid surface that will not wear out or come off. These plates fit all ZipWall spring loaded products. They are easy to clean and accept the new tether.

Includes:

• Two non-skid plates

The GripDisk™ was developed to meet the need for a product that would keep the ZipWall pole securely in place when contractors contend with a slick and slippery work site floor, such as highly polished wood or marble. The GripDisk is a non-skid, rubberized disk. This product holds the ZipWall pole tightly in place against the floor surface.

Includes:

• Two GripDisks